NATIONAL ELECTRICAL CODE

The easy way to use the Code Book Install the tabs from
bottom to top with 10 tabs to a row. 
Install short row on top of book (follow instructions).
Check them off as you install them!!

Why use Smart Tabs?—Because it saves time!!!

The only blue tab is on the article that has a required color code of
blue and blue lettering on white tabs for the annex (C).  
Red lettering for hazardous locations & emergency systems that are most used.
Green for grounding with the tabs marked to show when to use it for the
line or load side of the main at your service.
Orange and yellow for the most used tabs in her Code Book.
White covers the remainder of the Code articles.

Relax and let the tabs work for you, have fun using them!!!

C&L ENTERPRISES
5332 NE Holiday Drive ● Lee's Summit, MO 64064
Tel/Fax 816-795-9380
E-mail sales@smarttab.net

© 1999-2007

ORDER ONLINE                       PRINT ORDER FORM

1. Open the Code Book to the Code article listed on the tab.
2. Install the first tab it should be the last bottom tab listed in row 8. Install the first tab at the bottom right edge of the opened book, lining up straight the colored part of the tab with the edge of the paper, make sure glue does not extend beyond edge of paper. The rows should be from bottom to top on the right side of your book. The page number to install the tabs is given on each tab.
3. The next 9 tabs in the same row are to be installed with tabs overlapping about 1/8 inch.
4. You should end up with 8 rows of tabs.
5. Now go to the top of the book and install the motor and over 600 volt tabs. (follow the instructions.)